Classen TR-20B T Manuel de l'opérateur télécharger pdf (Page 10)

RA-21

CONTROLS / ASSEMBLY INSTRUCTIONS

SET-UP INSTRUCTIONS

NOTE: Units ship with no gas or oil.

1. Cut banding and roll aerator off pallet.

2. Unfold by pulling up on handle 1. Slide lock rings

down

3. Add oil to the engine with the engine resting in a level

position. Refer to the engine manufacturer’s Owners

manual for the correct type and amount of oil.

4. Fill the fuel tank according to the engine manufacturer

specications.

CONTROLS

FUEL SHUT OFF(A)

Move to the “OFF” position to shut off the fuel

whenever transporting the machine by trailer or

storing it. Move to the “ON” position before starting

the engine.

CHOKE (C)

Move to the choke position to apply the choke. Move

to the run position to remove the choke.

THROTTLE (D)

Controls the engine speed.

BELT IDLER HANDLE (F)

This lever engages the drive belt idler. Pull it back to

engage. This lever must be held back for operation.

When released, forward motion will stop. If the lever

fails to spring forward when released, immediately

contact the manufacturer as this is a safety feature.

TINE BLOCK LEVER (G)

This lever swings the tine block into the operating

position. Release the handle and allow lever to move

forward. This will place it into the operating position.

ENGINE SWITCH (H)

Move to the “OFF” position to stop the engine.

Move to the “ON” position before starting the engine.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Classen TR-20B T Manuel de l'opérateur Page 10